Vacuum deposition machines and processes for:
Webs
Non-metal webs
Metal webs
Glass
Powders
3D Parts
Vacuum machines and processes for:
Solar materials
Battery materials
Display materials
Components
Sputter magnetrons
Pretreatment devices
Evaporation devices
Sheet resistance measurement roller
Special equipment
Drying machines
Laminators
Contract coating














Sidrabe, Inc.
Riga, Latvia LV-1073
Tel: +371 67249806
Fax: +371 67139506
E-mail: sidrabe@sidrabe.eu

Components/Sheet resistance measurement roller

The SRMR-3 is a device for in-situ contact measurements of sheet resistance within a range of 5 -1000 (10,000) Ohm/sq. on polymer films in continuous technological process. A device can be used in vacuum and in air. Device SRMR-3 can be used in the systems of automatic control for deposition of the conducting coating with the assigned sheet resistance. The measurements are carried out continuously and are visualized in the PC display.

SRMR-3 is formed of dielectric roller with copper contact rings, connected to a current collector. In the deposition cycle polymer film wraps the roller by 90º - 180º, touching the contact rings with coated side. In the process of measurements the polymer film must evenly fit closely to the roller. Sheet resistance is measured in 3 zones over film width. The measurements are carried out on alternating current. This allows eliminating interference from operating magnetron and others chamber devices.

Current collector is connected to electronic unit via electrical vacuum feedthrough mounted on a flange. Electronic unit has an on/off toggle switch; printed control board; power supply; control input-output board; a few inputs for external connections; power cable. Electronic unit is connected with PC for measurements display via USB/ADC ports. Analogous output of the electronic unit can be switched from USB/ADC and PC over to ADC/PLC.
Sheet resistance measurement roller SRMR-3

Technical parameters

Distance between utmost contact rings: 550 mm
Distance between lateral contact rings: 90 mm
Measurement zones over film width: 3 pc.
(Can be changed at will of customer)
Measurement range: 5 - 1000 (10,000) Ohm/sq.
Roller diameter: 150 mm

Operating conditions

Ambient conditions: atmosphere, vacuum
Ambient temperature: 15 - 35 ºC
Humidity (without condensate), no more 60%
Feeding voltage: on the demand of the customer
Power consumption: no more 10 VA
The polymer film must evenly fit closely to the roller


Set of delivery

Dielectric roller with contact rings, current collector and mounting fixture
Flange for the installation of the electrical vacuum feedthrough
Electrical vacuum feedthrough
Electronic unit: power supply, USB-output for interface with USB/ADC and PC, or for the SRMR-3 integration to the process controls
Analog-digital converter (ADC)
Connection cables for the device components
Software
User manual
Copyright 2001-2008 Sidrabe, Inc.
Designed by dfm